Weldless Attachment Keg Keggle Sparge Assembly with Bulkhead
Weldless Attachment Keg Keggle Sparge Assembly with Bulkhead
Weldless Attachment Keg Keggle Sparge Assembly Components
Weldless Attachment Keg Keggle Sparge Assembly Connection Closeup
Weldless Attachment Keg Keggle Sparge Assembly Cross Closeup

Sparge Assembly - Keg / Keggle - Weldless

Average rating:
average rating 96%
(5)
Stainless steel sparge assembly for converted kegs. Weldless bulkhead assembly (included).
$84.98
SKU 1690
Order Options:
Qty

Stainless steel sparge assembly for converted keg/keggle.

Works with any converted 1/2 barrel (15.5 gallon) keg including American, European, or Coors "belly keg".

Weldless bulkhead connection kit included. Requires a 7/8" drilled hole near the top of the keg.

Strategically engineered 1/8-inch holes (32 of them) in pipes AND cross fitting assure constant flow and even distribution.

Works with gravity feed of sparge water. Use a pump and ball valve for best results.

 

Save $35.00 if you would rather drill your own holes. Just modify the selection in the pull-down menu below. NOTE: It is best to start with fewer holes, then increase hole count and location to fit your specific flow control needs.

Average rating:
average rating 96%
5 reviews

Featured positive reviews:

average rating 100%
Great so far! 06/19/2018
By Keenan McKamey
I replaced the Norcal weldless set up with 1/2 inch nuts with recessed o-ring areas on both sides so I can't comment on the weldless fitting.

As for the actual sparge arm, the build quality is great, the holes are perfectly in line, and the removable setup is a godsend. Flow rates were good for a recirculating mash.

Only real con is assembly, I wish there was a way to mark which sections of pipe go into which hole from Norcal since they send it broken down. It took me about twenty minutes to put it together and get all holes facing the right direction. If you are drilling your own this wont be an issue.
average rating 100%
Sparge 07/24/2017
By Eric Yocum
I have searched the web for a stainless sparge arm and this is by far the best one out there. It is super easy to install. You also will not find a better company to deal with. They genuinely care about what you are trying to accomplish and will bend over backwards to help.
average rating 100%
Love my new Keggle Sparge Assmenble 08/20/2013
By Efren Hidalgo
I'd been toying with the idea of creating something very similar to this when I happened to come across this on Jay's site. I've used it twice and when you connect it to a valve to control flow rate, it works like a dream. Worth buying.
 

Other items you might want to order:

0396_Half_Inch_Silicone_Tubing.jpg
Pin It Bookmark and Share