Dip Tube - Straight Wall Keg - 1/2” Diameter - Welded

Custom built dip tube with compression fitting cut to fit your exact needs for any hot liquor tank, mash / lauter tun, or boil kettle application.

Features:

• 304 stainless steel
• 1/2" NPT Male connection
• 1/2" outer diameter draw tube

In shopping cart, you will be asked to give the following measurements:

1) Distance (horizontal) from closest end of coupling to CENTER of your vessel.

2) Distance (vertical) from top of coupling to BOTTOM of your vessel - at the location of the vessel where you want the dip tube to terminate

Typically in a converted Sanke keg application (15.5 gallon and 50 liter kegs) the measurements will be close to the following:

• Vertical measurement: 3-5/8"
• Horizontal measurement:
  • Welded connection (coupling welded to OUTSIDE of keg): 7.5"
  • Weldless connection (bulkhead coupling is INSIDE of keg): 6"

If you feel comfortable cutting the dip tube yourself, you can specify a slightly larger size than you need, then cut it down (using a hack saw) to fit your application.

 YouTube Video: How to Set the
Ferrules on a Dip Tube Compression Fitting