stainless steel sparge assembly for 55 gallon drum
stainless steel sparge assembly for 55 gallon drum
stainless steel sparge assembly for 55 gallon drum close up
stainless steel sparge assembly for 55 gallon drum union end

Sparge Assembly - Drum

gray stars
Stainless steel sparge assembly for drums. Connection for welded assembly using a union (nipple included).
$149.99
SKU 1691
Qty

Drum Sparge Assembly

for 55 Gallon Drums

304 Stainless Steel

Stainless steel sparge assembly works with any converted 55 gallon drum.

Connection for welded assembly using a union. 1/2" NPT nipple included (you will need to weld the nipple to the drum wall).

Strategically engineered 1/8-inch holes (56 of them) in pipes AND cross fitting assure constant flow and even distribution.

Use a pump and ball valve for best results.

Save $45.00 if you would rather drill your own holes. Just modify the selection in the pull-down menu below. NOTE: It is best to start with fewer holes, then increase hole count and location to fit your specific flow control needs

Over-all length on the welded (longest side): 20-1/4". Length once installed and tightened is approximately 19-7/8"
Pin It Bookmark and Share