Tri Clover - Blow Off Tube - 1.5" MNPT

gray stars
1.5" Tri Clover 304 stainless steel fermenter blow off tube. Prevents crimped hose back pressure. Clamp and gasket sold separately.
SKU 3610

Tri Clover Fermenter Blow-Off Tube

1.5" TC x 10” Long x 1/2" Diameter

1/2" Male NPT Connector

304 Stainless Steel


Customers expressed an interest in having NO HOSE in their blow-off setups. They wanted us to develop an ALL STAINLESS blow-off system, while introducing the ability to close off CO2 escape and ferment under pressure.

You asked – we responded!

We took our 1.5” Tri Clover blow-off tube (SKU# 2787) and welded a 1/2” Male NPT hardware fitting to the end, allowing the connection of any 1/2" Female NPT device (such as a ball valve, nipple, etc).

This component is the cornerstone of our “1.5 Inch Tri Clover All Stainless Blow Off System” (see SKU# <TBD>)

Replace soft hose with a METAL arm that clamps to the top of your fermenter with a Tri Clover clamp. The entire arm is made of 304 stainless steel extending all the way past the edge of your fermenter. NO MORE CRIMPED HOSES!


·         All components are 304 Stainless Steel

·         Over-all Height is 3.6 inches

·         Length of tube (from outside edge of 90 degree angle to outside edge of 90 degree angle) is 9.25 inches

·         Over-all Length is 10 inches

·         Tube is .5” outer diameter

·         Half-inch Male NPT fitting on blow-off end

·         Tri-clover connection on fermenter connection end attaches with 1.5” tri clover clamp (SKU# 0808 - sold separately) and gasket (SKU# 1676 - sold separately)

Other items you might want to order:

Jaybird Tri Clover Tri Clamp 1.5 inch threaded filp-out hand bolt
Tri Clover - Clamp - 1.5"
Average rating:
average rating 100%
Tri Clover - Gasket - 1.5" - Silicone
Average rating:
average rating 100%
Pin It Bookmark and Share